The anti climbing device for escalators is a barrier device installed on the upper and the lower ends of escalators or automatic sidewalks when the escalator and the wall exceed 12.5 centimeters.

Use material

Most of the escalator anti climbing devices on the market are made of acrylic materials, and their properties are as follows:

1. The thermal deformation temperature of the ordinary acrylic plate is about 100 degrees, and the continuous use temperature should not be higher than 90 degrees.

2, the acrylic board is easy to produce static electricity, adsorb dust. When cleaning, use soft cotton cloth to dip in 1% soapy water.

3, the surface hardness of acrylic plate is equivalent to the aluminum material, in use or processing should be careful to avoid surface scratch. If it was scratched,

The original gloss surface can be restored by polishing.

Installation necessity

On the elevator in the public place, there are no lack of children chasing and playing. Although many escalators are marked by "no climbing and playing" and "children must be taken under adult supervision", the installation of the elevator handrail anti climbing device will also reduce the risk of accidents.

Therefore, whenever a wall is adjacent to 12.5 centimeters or more, a blocking device shall be installed on the upper and lower ends of escalators or automatic sidewalks, so as to prevent personnel from entering the outer cover plate area and cause falling accidents.

Usage method

If there is a risk of falling, appropriate measures should be taken to prevent the personnel from climbing to the outside of the armrest device. To ensure this, outer cover of escalators and moving on should be fitted with anti climbing device, anti climbing device is located in the plane of H9 (1000 + 50mm), lower intersect with the outer cover plate, extending the length of L5 is parallel to the direction of the outer cover plate should not be less than 1000mm, and should ensure that this long range no foot at.